Which model linksys router do you have? I am curious because I have one too and it doesn't disconnect me after every transfer.
The correct procedure is as followed.
Bind to IP is intended for non-passive mode transfers (active mode). In order for this to work correctly you will need to set your machine in DMZ mode or configure port forward a range (i.e. 9000 to 9005) of ports on the router.
If you setup port forwarding on a range of ports then you'll need to match this range (i.e. 9000 to 9005) in FlashFXP.
It is ideal to limit this range to 5 ports per instance of FlashFXP, so if you often run two copies of FlashFXP at once you would use 9000 to 9010.
|
Threaded Mode