When making changes to files in FXP I am getting errors when the programs are being r
I am using FLASH FXP to transfer files from our unix based cmm's to our windows based servers. The problem I am having, is when I used FLASH FXP to connect to one of the cmm's and make a simple change, such a revision date to the program and then close FXP and try to run the program, I will get a sytax error and the program will not run even though it was working fine 5 minutes before i went in and made a date change. I am sure the problem lies within a binary and ascii discrepency, but I am not sure how to rectify the situation. After this happens, you can sometimes use FLASH FXP to look at the program, and there will be ^M at the end of each line of the program. After these are removed it seems to take care of the problem. Any suggestions on how to avoid these problems would be great.
Thank you,
Mark Haupert
|
Threaded Mode