FlashFXP starts on wrong monitor

[Thany]

I have a dual-monitor setup, and I would like FlashFXP to start on the second monitor. FlashFXP 2.1 did this just fine. If it was on the 2nd monitor and I closed it, the next time I would start it, it would show up on the second monitor.

FlashFXP 3.0 always starts on the primary monitor, while it should just remember it's last monitor.

[Thany]

Too bad this hasn't been fixed in 3.0.2.1044...

Maybe someone forgot to put it to the todo list? ;)

[bigstar]

I sent you a private message

[bigstar]

Does build 1045 work better?

[Thany]

Sorry, haven't had a chance to try it out yet... I'll try it out next wednesday (which is at work, and I took the days off until then)

[Thany]

Ah I see build 1045 is already released. Unfortunately it still always starts on the primary monitor.

Sorry I didn't have the time to test it earlier...

[bigstar]

Could you please run the multi-monitor test program in this thread http://forum.flashfxp.com/showthread.php?s=&postid=25381#post25381

Thank You :)

[J-J]

Greetings,

I can not confirm this behavior. On my dual monitor system FlashFXP shows correctly on the monitor on which it was last closed/minimized.

/J-J

Results from multimonitor test program:

Monitor Count: 2
--------------------------
Monitor 1: Left: 0, Top: 0, Width: 1600, Height: 1200
Monitor 2: Left: -1600, Top: 0, Width: 1600, Height: 1200

[bigstar]

I appreicate the results J-J, could I please get your video card brand/model and driver version? Your system setup is the type that I need to test.

[J-J]

Greetings,

Here is the requested information

GeForce 4 TI-4200 64mb Bios: 4.25.00.28
Drivers: NVidia 6.14.10.6693
DirectX 9.0


/J-J

[Thany]

Originally posted by bigstar
Could you please run the multi-monitor test program in this thread http://forum.flashfxp.com/showthread.php?s=&postid=25381#post25381
I'll do that next monday or tuesday, when I'm at work again.

In the mean time, I can give you more detailed specs:
Matrox G550 dualhead, latest drivers
Two 1024x768 monitors
Secondary monitor on the right side of the primary monitor
Running UltraMon (don't think it's the very latest version)

[Thany]

Here's my output from multimontest:
Monitor Count: 2
--------------------------
Monitor 1: Left: 0, Top: 0, Width: 1024, Height: 768
Monitor 2: Left: 1024, Top: 0, Width: 1024, Height: 768

[bigstar]

[b]Thany[b], That's really odd, with your type of monitor configuration it should work. I'll see if I can figure anything out and get back to you.