mattchilton
08-09-2003, 11:56 AM
Hello, I'm trying to use FlashFXP to do an automatic daily upload to an (unfortunately) rather unreliable site, whose connection goes down for a few minutes per hour.
If I start the upload from the GUI, everything seems to work fine. I'm simulating the network outages by pulling the network cable out of the back of the machine, and FlashFXP prints up a message along the lines of "Connection to ftp.mysite.com lost." When I re-connect the cable it says "Reconnecting in 120 seconds" (or something similar), and it all works fine.
However, for my automatic daily upload I'm starting the program from the command line with:
FlashFXP -c2 daily_upload.fqf
When I test a network outage by pulling out the cable it acts as described above. However, when I put the cable back in, nothing happens. It doesn't try to reconnect. It just sits there.
Am I doing something wrong, or is this a bug?
Any help would be enormously appreciated.
Matt.
:confused:
If I start the upload from the GUI, everything seems to work fine. I'm simulating the network outages by pulling the network cable out of the back of the machine, and FlashFXP prints up a message along the lines of "Connection to ftp.mysite.com lost." When I re-connect the cable it says "Reconnecting in 120 seconds" (or something similar), and it all works fine.
However, for my automatic daily upload I'm starting the program from the command line with:
FlashFXP -c2 daily_upload.fqf
When I test a network outage by pulling out the cable it acts as described above. However, when I put the cable back in, nothing happens. It doesn't try to reconnect. It just sits there.
Am I doing something wrong, or is this a bug?
Any help would be enormously appreciated.
Matt.
:confused: