FXP'ing between active and passive ftp's

[evitaerc]

How can I fxp from a passive ftp to an active ftp? Or...as the administrator of the active ftp, would it be easier to set the active ftp (running using winxp iis) to passive, and if so...how?

Thanks

[MxxCon]

enable alternative fxp option in site manager

[evitaerc]

on both sites?

[MxxCon]

no, only on one. doesn't matter which, as long as you check proper box (download or upload)

[evitaerc]

I don't know what I'm doing wrong but I still can't fxp the files. I changed the settings in site manager for the non passive ftp. I put a check mark in the box downloading (NOT PASV) I also unchecked the box that says Use Passive Mode. Before doing this I wasn't able to connect to the site at all, now I can connect but when I try to fxp the files, I get this error:

PORT x,x,x,x,x,x
200 PORT command successful.
STOR file.nfo
150 Opening ASCII mode data connection for file.nfo.
RETR file.nfo
426 Connection closed , transfer aborted (transfer failed).(no data connection)
ABOR
425 Can't open data connection.
225 ABOR command successful.
Transfer Failed!
PORT 192,168,1,15,15,95
200 PORT command successful.
LIST -al
150 Opening ASCII mode data connection for /bin/ls.
226 Transfer complete.
PASV
227 Entering Passive Mode (x,x,x,x,x,x)
LIST
150 Opening ASCII data connection for ls file/file.
226-free disk space under this directory : 22853 mb
226 Transfer finished successfully. Data connection closed.
Transfer queue completed
1 File failed to transfer

[bigstar]

It looks like the site is behind a router/firewall, You're going to need to check the option in the site manager "Site uses NAT/IPMASQ/Non-routable IP"